Filter
Top Products
Removing Misfed Paper
59
4
Note
❒
If the printer has the optional
paper feed unit installed, check
the all paper trays for misfeeds.
B
Slide the paper tray completely
into the printer.
Important
❒
Be sure to insert the paper tray
completely. If not fully inserted,
misfeeds might occur, or the
front cover might touch the pa-
per tray.
C
Open the front cover, and then
close it to reset the misfeed condi-
tion.
Bypass tray
A
Carefully pull out the misfed pa-
per.
Confirm that you do not leave any
misfed paper in the printer.
B
When paper is left in the bypass
tray, remove the paper.
C
Close the bypass tray, open the
front cover, and then close it to re-
set the misfeed condition.
D
Reload paper into the bypass tray.
When the Message "Open
Front Cover Remove Misfeed"
Appears
R
CAUTION:
A
Push the front cover release but-
ton and open the front cover.
B
If the misfed paper is in the front
of the photoconductor unit, care-
fully pull it out.
Note
❒
When removing misfed paper,
be careful not to touch the fus-
ing section because it could be
very hot.
TFWY180E
•
When removing misfed paper,
do not touch the fusing section
because it could be very hot.
TFWX080E
TFWX210E