Filter
Top Products
Common Problems
This section describes how to troubleshoot common problems that may occur while operating the
machine.
Problem Possible cause Solution
The machine does not turn on.
The power cord is not
connected properly.
• Make sure that the power
plug is firmly inserted into
the wall outlet.
• Make sure that the wall
outlet is not defective by
connecting another
working device.
An error message is shown on
the machine's screen.
An error has occurred.
See p.383 "Error and Status
Messages on the Screen".
Pages are not printed.
The machine is warming up or
receiving data.
Wait until "Printing..." appears
on the screen. If "Processing..."
is displayed on the screen, the
machine is receiving data.
Pages are not printed.
The interface cable is not
connected correctly.
• Reconnect the cable.
• Check that the interface
cable is the correct type.
Strange noise is heard.
The supplies or options are not
properly installed.
Confirm that the supplies or
options are properly installed.
Strange noise is heard.
The machine executes periodic
cleaning of the interior when
[Auto Cleaning] in [System
Settings] is set to [On].
The noise does not indicate a
malfunction. Wait until the
cleaning is complete.
The volume of the sounds
produced by the machine is too
loud.
The volume is set to the high
level.
Adjust the volume of the beep,
ring, speaker, and alarm
sounds. For details, see p.274
"System Settings".
The volume of the sounds
produced by the machine is too
quiet.
The volume is muted or set to the
low level.
Adjust the volume of the beep,
ring, speaker, and alarm
sounds. For details, see p.274
"System Settings".
9. Troubleshooting
354
9