Filter
Top Products
Problem Solution
Photocopied paper is dirty.
• Image density is too high.
Adjust the image density. See p.172 "Adjusting Image
Density".
• Toner on the printed surface is not dry.
Do not touch printed surfaces immediately after copying.
Remove freshly printed sheets one by one, taking care
not to touch printed areas.
• The exposure glass or ADF is dirty. See p.405
"Cleaning".
• Before placing originals on the exposure glass, make
sure that toner or correction fluid is dry.
When copying from the exposure
glass, the print area of the copy is
out of alignment with the original.
Place the original copy side down, making sure that it is
aligned to the rear left corner and pressed flat against the
exposure glass.
Copier Problems
375
9