Filter
Top Products
10
Q&A
CD-R/RW DRIVE
Q: Is it possible to use the CD-R/RW
drive which were used with the
previous VS models?
A: No, they cannot be used. Please use the built-in CD-R/RW
drive.
Q: Can the built-in CD-RW drive be
exchanged?
A: No, it cannot be exchanged.
Q: Which type of disc can be used with
the CD-R/RW drive?
A: There is no particular restriction but sometimes problems
may result due to the bad quality of the media or bad affinity
between the drive and one brand of discs. Before you
purchase many discs of one kind, please test one to be sure
that it can be used with your drive.
80-minute discs are not recommended because of their
thinner grooves for recording.
8cm CD-R disc (18-minute) can be used.
For your important project, we recommend you to backup in
multiple discs. Also, CD-R/RW disc is a delicate medium
and please handle and store with care according to the
precaution notes which come with the disc.
Q: If I write an additional project to
the CD-R disc which is not finalized,
will there be a silent gap between the
songs?
A: If you write in “Track at Once” mode, approximate 2
seconds of silence will be inserted in between automatically.
Q: Is it possible to do “CD Write/CD
Backup” in eight times speed?
A: No matter how fast the drive is, writing speed to
CD-R/RW is limited to four times.
Q: When creating audio CD with “CD
Write,” is it possible to write the
copyright bit?
A: No. Copyright bit is off when writing to CD-R.
Q: Is it possible to use the audio CD
which is written on VS-2400CD as a
master disc for mass duplication?
A: There are “Disc at Once” and “Track at Once” methods for
audio CD burning. Disc created with “Disc at Once” method
can be a press master.
Q: Is it possible to backup additional
Projects to a disc which already
contains one Project backup?
A: Project backups to CD-R, always use the Disc at Once
mode which finalizes the disc at the end of backup. So
additional writing of the data is impossible even if the disc
has room.
If you try to write another Project on CD-RW disc, you need
to first erase the entire disc.
Q: How long does it take backup the
Project on CD-R/RW?
A: A 600MB Project is equivalent to a CD-R/RW disc. To
backup this with four times speed, it will take about 15
minutes and another 15 minutes to verify the result, 30
minutes in total. This may vary by the Project data
configuration and performance of the hard disk.
Q: What type of PQ signals can I
record?
A: P and Q sub channel information is not generated by the
VS-2400CD, but the CD-R/RW drive automatically generates
these in accordance with the CUE sheet from the VS-2400CD.
In other words, the required markers for an audio CD such
as TNO (track number), INDEX (index number), P-Time
(program time) and A-Time (absolute time) are recorded
when a CD is written and finalized.
Q: Is it possible to backup a 1GB
Project on the CD-R/RW disc?
A: Yes. You can backup using multiple discs.
Q: Is it possible to capture audio
signals from an audio CD in the
CD-R/RW drive?
A: Yes.
Q: Is it possible to directly play back
the Project data in the CD-R/RW disc?
A: No, such function is not supported.
2400_app_e.book 10 ページ ２００５年４月２８日 木曜日 午後１時１４分