Filter
Top Products
47
Algorithm List
Algorithm List
Parameter (full name) Setting Function
EQ (Equalizer)
Sw (Switch) On, Off Turns the equalizer on or off.
Low Gain -12– +12 dB Sets the boost/cut amount in the low frequency band.
Low Freq (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low Q 0.3–10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings. *1
Low Type Shlv, Peak Sets the type of the low frequency band equalizer
(Shelving type or peaking type).
Mid Gain (Middle Gain) -12– +12 dB Sets the boost/cut amount in the middle frequency band.
Mid Freq (Middle Frequency) 200–8000 Hz Sets the center frequency in the middle frequency band.
Mid Q (Middle Q) 0.3–10.0 Sets the width of the area around the middle frequency that
will be affected by the gain settings.
High Gain -12– +12 dB Sets the boost/cut amount in the High frequency band.
High Freq (High Frequency) 1.4–20.0 kHz Sets the center frequency in the High frequency band.
High Q 0.3–10.0 Sets the width of the area around the High frequency that
will be affected by the gain settings. *1
Hi Type (High Type) Shlv, Peak Sets the type of the High frequency band equalizer (Shlving
type or peaking type).
Level (Output Level) 0–100 Sets the volume after passing through the equalizer.
Reverb: Adds reverberation.
Room Size (Room Size) 5–40 m Sets the size of the room.
Time (Reverb Time) 0.1–32.0 sec. Sets the time length of the reverb sound.
PreDLY (Pre-Delay) 0–200 ms Sets the time until the reverb sound appears.
Difusi (Diffusion) 0–100 Sets the extent of diffusion of the early reflection sound.
Densty (Density) 0–100 Sets the density of the reverb sound.
ERLvl (Early Reflection Level) 0 to100 Sets the volume of the early reflection.
LF Damp Gain (LF-Damp Gain) -36–0 dB Sets the degree of attenuation of the reverb in the low
frequency band.
LF Damp Freq (LF-Damp Frequency) 50–4000 Hz Sets the frequency on which the reverb starts attenuating in
the low frequency band.
HF Damp Gain (HF-Damp Gain) -36–0 dB Sets the degree of attenuation of the reverb in the High
frequency band.
HF Damp Freq (HF-Damp Frequency) 1.0–20.0 kHz Sets the frequency on which the reverb starts attenuating in
the High frequency band.
HiCF (High Cut Frequency) 0.2–20.0 kHz Sets the frequency for which the High frequency band
elements of the reverb are cut.
FX Lvl (Effect Level) -100–100 Sets the volume of the reverb sound.
DirLvl (Direct Level) -100–100 Sets the volume of the direct sound.
*1: If Low Type (Lo Type) or High Type (Hi Type) is set to “Shlv (Shlving Type),” the setting for Lo Q or High Q is
invalid.
* “Reverb” cannot be used on EFFECT2 and 4 (even-numbered effects).
* “Reverb” cannot be used on the projects with 64kHz or higher sampling rate.
2400_app_e.book 47 ページ ２００５年４月２８日 木曜日 午後１時１４分