Filter
Top Products
96
Algorithm List
Parameter (full name) Setting Function
SpMod (Speaker Modeling): Selects the speaker subject to characteristics modeling.
Sw (Switch) Off, On Turns the Speaker Modeling on or off.
Model (Model) See the column on
the previous page. Specifies the speaker actually generating sounds.
Output Speakers (Output Speakers) DS-90/DS-90A, DS-50A
Phase (Phase) NRM, INV Sets the phase of the speaker. “NRM” for the same phase,
and “INV” for the inverted phase.
BCut (Bass Cut Filter): Cuts off undesired low sounds such as pop noise.
Sw (Switch) On, Off Turns the bass cut filter on or off.
Freq (Frequency) Thru, 20 - 2000 Hz Sets the frequency for cutting off undesired low frequency
band sounds such as pop noise.
LFT (Low Frequency Trimmer): Adjusts the low frequency band sounds.
Sw (Switch) On, Off Turns the low frequency trimmer on or off.
Gain (Gain) -12– +12dB Sets the boost/cut amount.
Freq (Frequency) 20–2000 Hz Sets the center frequency of the trimmer.
HFT (High Frequency Trimmer): Adjusts the High frequency band sounds.
Sw (Switch) On, Off Turns the High frequency trimmer on or off.
Gain (Gain) -12– +12dB Sets the boost/cut amount.
Freq (Frequency) 1.0–20.0 kHz Sets the center frequency.
Lmt (Limiter): Prevents distortion by suppressing signals at High levels.
Sw (Switch) On, Off Turns the limiter on or off.
Thresh (Threshold) -60–0 dB Sets the volume at which the limiter starts working.
Release (Release) 0–100 Sets the time from when the input level drops below the
threshold level to when the effect ceases to apply.
Level (Level) -60– +24 dB Sets the volume after passing through the limiter.
2400_app_e.book 96 ページ ２００５年４月２８日 木曜日 午後１時１４分