Filter
Top Products
61
Algorithm List
Algorithm List
Chorus: Adds spaciousness and depth to the sound.
Sw (Switch) On, Off Turns the chorus on or off.
Rate (Rate) 0.1–10.0 kHz Sets the rate of modulation.
Depth (Depth) 0–100 Sets the depth of modulation.
PreDLY (Pre-Delay) 0–50 ms Sets the time delay from when the direct sound begins until
the processed sound is heard.
Lch FeedbackLvl (Lch Feedback Level) -100–100 Sets the amount of the left-side chorus sound should be
returned to the left chorus input.
Rch FeedbackLvl (Rch Feedback Level)
-100–100 Sets the amount of the right-side chorus sound should be
returned to the right chorus input.
Lch CrossFeedbackLvl (Lch Cross-Feedback Level)
-100–100 Sets the amount of the left-side chorus sound should be
returned to the right chorus input.
Rch CrossFeedbackLvl(Rch Cross-Feedback Level)
-100–100 Sets the amount of the right-side chorus sound should be
returned to the left chorus input.
FX Lvl (Effect Level) -100–100 Sets the volume of the chorus sound.
DirLvl (Direct Level) -100–100 Sets the volume of the direct sound.
EQ (Equalizer)
Sw (Switch) On, Off Turns the equalizer on or off.
Low Gain (Low Gain) -12– +12 dB Sets the boost/cut amount in the low frequency band.
Low Freq (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low Q 0.3–10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings.1 *2
Low Type Shlv, Peak Sets the type of the low frequency band equalizer
(Shlving type or peaking type).
Mid Gain (Middle Gain) -12– +12 dB Sets the boost/cut amount in the middle frequency band.
Mid Freq (Middle Frequency) 200–8000 Hz Sets the center frequency in the middle frequency band.
Mid Q (Middle Q) 0.3–10.0 Sets the width of the area around the middle frequency that
will be affected by the gain settings.
High Gain -12– +12 dB Sets the boost/cut amount in the High frequency band.
High Freq (High Frequency) 1.4–20.0 kHz Sets the center frequency in the High frequency band.
High Q 0.3–10.0 Sets the width of the area around the High frequency that
will be affected by the gain settings.1 *2
Hi Type (High Type) Shlv, Peak Sets the type of the High frequency band equalizer (Shlving
type or peaking type).
Level (Output Level) 0–100 Sets the volume after passing through the equalizer.
*1: The sum of the Delay Time (Time) value and the Delay Shift (Shift) value should not exceed the setting range of
Delay Time. For example, if the delay time is set to 300 ms, the setting range of Delay Shift is L200 to R200 ms.
*2: If Lo Type (Low Type) or Hi Type (High Type) is set to “Shlv (Shlving Type),” the setting for Lo Q or High Q is
invalid.
2400_app_e.book 61 ページ ２００５年４月２８日 木曜日 午後１時１４分