Filter
Top Products
76
Algorithm List
Dly (Delay):Adds a delayed sound to the direct sound, adding depth to the sound or creating special effects.
Sw (Switch) On, Off Turns the delay on or off.
Time (Delay Time) 0–1000 ms
Sets the time from direct sound until when the delay sound is heard.
*1
shift (shift) L1000–0–R1000 ms
Sets the delay time difference between the right and left delay sounds.
FBTim (Feedback Delay Time) 0–1000 ms Sets the feedback repetition cycle.
FBLvl (Feedback Level) -100–100 Sets the amount of the delay sound should be returned to the delay
input.
FX Lvl (Effect Level) -100–100 Sets the volume of the delay sound.
DirLvl (Direct Level) -100–100 Sets the volume of the direct sound.
*1:The sum of the Delay Time value and the Delay shift value should not exceed the setting range of Delay Time.
For example, if Delay Time is set to 800 ms, the setting range of Delay shift is L200 to R200 ms.
Guitar Amp Modeling (Guitar Amplifier Modeling)
Models a guitar amplifier.
fig.08-34
Parameter (full name) Setting Function
NS (Noise Suppressor): Mutes noise in the silent mode.
Sw (Switch) On, Off Turns the noise suppressor on or off.
Thresh (Threshold) 0–100 Sets the level to start muting noise.
Release (Release) 0–100 Sets the time over which the volume will drop to 0 after the noise
starts being muted.
AMP (Pre-Amplifier): Models the pre-amplifier section of a guitar amplifier.
Sw (Switch) On, Off Turns the compressor on or off.
Amp Type (Pre-amplifier type) See the column on
the next page. Sets the type of the guitar amplifier.
Gain (Gain) Low, Middle, High Sets the degree of sound distortion on the pre-amplifier.
Bright (Bright) On, Off
You can set this on to generate clear-cut bright sounds.
*1
Volume (Volume) 0–100 Sets the volume and degree of distortion of the amplifier.
Bass (Bass) 0–100 Sets the tone of the low range.
Middle (Middle) 0–100 Sets the tone of the middle range. *2
Treble (Treble) 0–100 Sets the tone of the High range.
Presence (Presence) 0–100 (-100–0) Sets the tone of the ultra-High range. *3
Master (Master) 0–100 Sets the volume of the entire pre-amplifier
Sp (Speaker Simulator): Models a speaker.
Sw (Switch) On, Off Turns the speaker simulator on or off.
Sp Type (Speaker Type) See the column on
the previous page. Sets the speaker type.
Mic Setting (Microphone Setting) 1, 2, 3 Sets the location of the microphone that is recording the sound of
the speaker.This can be adjusted in three steps, with the
microphone becoming more distant in the order of 1, 2, and 3.
MicLvl (Microphone Level) 0–100 Sets the microphone volume.
Noise Suppressor
G-Amp
Speaker Modeling
Output L
Output R
Input L
Input R
2400_app_e.book 76 ページ ２００５年４月２８日 木曜日 午後１時１４分