Filter
Top Products
85
Algorithm List
Algorithm List
Parameter (full name) Setting Function
Voc (Vocoder 2): The pitch is specified as in the instrumental sound while the tone is output in
the human voice.
Envelope (Envelope) Sharp, Soft, Long Defines characteristics of the sound.
PanMode (Pan Mode) Mono, Stereo, L
→
R, R
→
L Defines how the sound is located.
Hold (Hold) On, MIDI Specifies that an instrumental sound is or is not issued
with the formant fixed.
MicSens (Microphone Sensitivity) 0–100 Sets the input sensitivity of the microphone.
SynInLvl (Synthesizer In Level) 0–100 Sets the input level of the instrumental sound.
Character Ch1 – 19
(Voice Character Channels 1 - 19) 0–100 Sets the tone of the vocoder.
Mic (Microphone Mix) 0–100 Sets the amount of the sound after passing through the
microphone HPF should be mixed into the Vocoder
output.
MicHPF (Microphone HPF) Thru, 1.0–20.0 kHz Sets the frequency at which HPF on the vocal sounds
through the microphone starts taking effect.
Sets this to “Thru” if HPF is not desired.
MicPan (Microphone Pan) L63–R63 Sets the panning of vocal sounds through the
microphone.
NSThresh (Noise Suppressor Threshold) 0–100 Sets the volume to start muting noise on the
instrumental sound input.
Cho (Chorus): Adds spaciousness and depth to the sound.
Sw (Switch) On, Off Turns the chorus on or off.
Rate (Rate) 0.1–10.0 Hz Sets the rate of modulation.
Depth (Depth) 0–100 Sets the depth of modulation.
PreDly (Pre-Delay) 0–50 ms Sets the time delay from when the direct sound begins
until the chorus sound is heard.
MixBal (Mix Balance) 0–100 Sets the volume balance between the chorus sound
and the direct sound.
2400_app_e.book 85 ページ ２００５年４月２８日 木曜日 午後１時１４分