Filter
Top Products
16
Error Messages
Aborted Command!
Illegal Request!
This disk drive cannot be used by the VS-2400CD.
Arbitration Failed!
Check Condition!
Drive Status Error!
The disk drive could not be accessed. Make sure that the disk
drive is connected correctly.
Blank Disc
The CD in your drive is blank. Insert a CD or CD-R/RW that
contains recorded material.
Can't Communicate!
Drive Time-out!
Message Error!
Phase Mismatch!
Undefined Sense!
Unknown Drive Error!
There is a problem with your disk drive connection. Make
sure the disk drive is connected correctly.
Cannot write in “Track at Once” format on
CD-RW Disc!
You have tried to write the audio data in “Track at Once”
format with a CD-RW disc in the drive.
Can't record CD!
Digital recording from a CD player is not enabled. Please
read “CD Digital Parameter” and “Changing the Routing (EZ
Routing Condition)” (Owner's Manual).
Can't Set Marker!
Track number markers must be at least four seconds apart.
DIGITAL In Lock
R-BUS Lock
The sample rate reference clock is set by the digital signal
received at the DIGITAL IN connector as shown above. You
can now record the digital signal.
DIGITAL In Unlock
Change to Internal Clock?
R-BUS Unlock
Change to Internal Clock?
You cannot yet record the incoming digital audio because it
is not being received by the DIGITAL IN connector as shown
above, or because the project sample rate and the sample rate
of the digital device connected to the DIGITAL IN are
different.
Switch the sample rate reference clock to the VS-2400CD's
internal clock by pressing
[ENTER/YES]
. After checking to
make sure that all digital devices are properly connected and
that the sample rates for all of the devices match, try this
operation again.
Drive Busy!
If this message appears when you first begin using a disk
drive with the VS-2400CD, the disk drive is not fast enough.
You may still be able to use this disk with projects that have a
lower sample rate or use a different recording mode.
If this message appears after you have been using a disk
drive with the VS-2400CD, the data on the disk drive has
become fragmented. This will unacceptably slow down the
reading and writing of data. Try bouncing the current track
to re-record its data onto another track, or optimize your
project. If this message still appears after these measures
have been taken, copy the project data to another disk drive
and initialize the disk drive that experienced the problem.
Drive Not Ready!
The disk drive is not yet ready. Please wait a moment.
Exceeding limit of RSS PAN Channels!
You have reached the maximum number of channels for
which RSS pan can be used.
Finalized CD!
The CD is a commercial CD or a CD-R/RW disc you have
already finalized. Replace the disc with a blank disc or one
that has not yet been finalized.
Found Illegal Track Pair!
Found Illegal Phrase Pair!
Illegal Track Pair!
Illegal Phrase Pair!
You are trying to Region Edit or Phase Edit (Copy, Move, or
Exchange etc.) between a V-Track recorded using
CDRRecMode and a V-Track recorded using some other
recording mode. Use V-Tracks that were recorded using the
same recording mode.
2400_app_e.book 16 ページ ２００５年４月２８日 木曜日 午後１時１４分