Filter
Top Products
51
Algorithm List
Algorithm List
Parameter (full name) Setting Function
GRev (Gate Reverb): Mutes the revert sound midway.
Sw (Switch) On, Off Turns the gate reverb on or off.
Mode (Gate Mode) See the column on
the previous page. Defines how the reverb sound is applied.
Time (Gate Time) 10–400 s Sets the time from when the reverb sound begins until it is
muted.
PreDLY (Pre-Delay) 0–300 ms Sets the time until the reverb sound appears.
Thick (Thickness) 0–100 Sets the thickness of the reverb sound.
Densty (Density) 0–100 Sets the density of the reverb sound.
AcDLY (Accent Delay Time) 0–200 ms Sets the time from when the reverb sound is muted until the
accent sound appears.
AcLvl (Accent Level) 0–100 Sets the volume of the accent sound.
AcPan (Accent Pan) L63–R63 Sets the pan of the accent sound.
FX Lvl (Effect Level). -100–100 Sets the volume of the gate reverb sound.
DirLvl (Direct Level) -100–100 Sets the volume of the direct sound.
EQ (Equalizer)
Sw (Switch) On, Off Turns the equalizer on or off.
Low Gain (Low Gain) -12– +12 dB Sets the boost/cut amount in the low frequency band.
Low Freq (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low Q 0.3–10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings.1 *1
Low Type Shlv, Peak Sets the type of the low frequency band equalizer
(Shlving type or peaking type).
Mid Gain (Middle Gain) -12– +12 dB Sets the boost/cut amount in the middle frequency band.
Mid Freq (Middle Frequency) 200–8000 Hz Sets the center frequency in the middle frequency band.
Mid Q (Middle Q) 0.3–10.0 Sets the width of the area around the middle frequency that
will be affected by the gain settings.
High Gain -12– +12 dB Sets the boost/cut amount in the High frequency band.
High Freq (High Frequency) 1.4–20.0 kHz Sets the center frequency in the High frequency band.
High Q 0.3–10.0 Sets the width of the area around the High frequency that
will be affected by the gain settings.1 *1
Hi Type (High Type) Shlv, Peak Sets the type of the High frequency band equalizer (Shlving
type or peaking type).
Level (Output Level) 0–100 Sets the volume after passing through the equalizer.
*1: If Low Type (Lo Type) or High Type (Hi Type) is set to “Shlv (Shlving Type),” the setting for Lo Q or High Q is
invalid.
* “Gate Reverb” cannot be used on EFFECT2 and 4 (even-numbered effects).
* “Gate Reverb” cannot be used on the projects with 64kHz or higher sampling rate.
2400_app_e.book 51 ページ ２００５年４月２８日 木曜日 午後１時１４分