Roland VS-2400 Switch User Manual


 
73
Algorithm List
Algorithm List
Parameter (full name) Setting Function
Lnk (Link): Channel B follows the settings for Channel A.
Link (Link Switch) On, Off Specifies if Channel B follows or does not follow the
settings for Channel A.
CnvA, CnvB (Mic Converter):Converts the characteristics of the low-end general-purpose microphone into
the characteristics of the High-end microphone for studio application.
Sw (Switch) On, Off Turns the microphone converter on or off.
Input (Input) See the column on
the previous page. Sets the microphone type used for recording.
Output (Output) See the column on
the previous page. Sets the microphone types to be Modeled.
Phase (Phase) Nor, Inv Sets the microphone phase.
BCutA, BCutB (Bass Cut Filter): Cuts off undesired low frequency band sounds such as pop noise.
Sw (Switch) On, Off Turns the bass cut filter on or off.
Freq (Frequency) Thru, 20 - 2000 Hz Sets the frequency for cutting off undesired low frequency
band sounds such as pop noise.
DstnA, DstnB (Distance): Models the frequency characteristics and time difference due to distance
difference.
Sw (Switch) On, Off Turns the distance on or off.
Prox.Fx (Proximity Effect) -12– +12 Corrects the low frequency band characteristics due to the
distance from the sound source.
Time (Time) 0–3000 cm Models the time difference due to the distance from the
sound source.
LmtA, LmtB (Limiter): Prevents distortion by suppressing signals at High levels.
Sw (Switch) On, Off Turns the limiter on or off.
Thrsh (Threshold) -60–0 dB Sets the volume level to start suppressing excessive input.
Attack (Attack Time) 0–100 Sets the time from when the input level exceeds the
threshold level to when the effect begins to apply.
Release (Release Time) 0–100 Sets the time from when the input level drops below the
threshold level to when the effect ceases to apply.
Detect HPF Freq (Detect HPF Frequency) Thru, 20 - 2000 Hz Normally, sets “Thru”.
Sets the cutoff frequency of the level detection section.
Level (Output Level) -60– +24 dB Sets the volume of the compressor sound.
2400_app_e.book 73 ページ 2005年4月28日 木曜日 午後1時14分