Filter
Top Products
17
Error Messages
Error Messages
FX Board for RSS PAN is not installed!
When a project or scene was loaded, the effect board
necessary for using RSS pan was not found.
Hardware Error!
There is a problem with the disk drive. Contact the disk
drive's manufacturer or dealer.
Illegal Track!
You are trying to create a new phrase using a V-Track
recorded in CDRRecMode and a V-Track recorded using
some other recording mode. Please use V-Tracks that were
recorded using the same recording mode.
AUTOMIX: Event Memory Full!
Event Memory Full!
The project already contains all of the events it can hold.
Delete unneeded automix data or perform a Project Optimize
operation.
Lack Of Event!
You have tried to undo or redo when the remaining number
of free project events is less than 200. This operation cannot
be performed.
Disk Memory Full!
Lack of IDE Memory!
There is insufficient free space on the disk. Erase unneeded
data or select a different disk drive. The current disk
partition already contains 200 projects, the maximum
number of projects it can hold. Delete unneeded projects or
select a different disk drive.
CD-RW Memory Full!
There is not enough room on the CD-R/RW disc.
MARKER Memory Full!
The project already contains 1000 markers, the maximum
number it can hold. Delete unneeded markers.
Medium Error!
Track 0 Not Found!
Medium Error!
There is a problem with the disk drive media or CD. This
disk cannot be used by the VS-2400CD. In some cases, data in
the disk drive can be recovered using the Drive Check
operation.
Invalid Disc!
It is not the ISO9660 format CD.
No Data on the Source Tracks!
The project you have selected contains no data.
Not 44.1kHz Project!
The project's sample rate is not 44.1 kHz. Only 44.1 kHz
audio can be written to a CD-R/RW disc.
Operation Failed!
Processing was halted due to insufficient memory or due to
an error that occurred in the disk drive itself. Check your
connections and verify the reliability of your hard drive.
Project Protected!
Since Project Protect is on, the operation cannot be executed.
TOC Error!
An error occurred while reading the CD-R/RW disc. There is
a problem with the Roland CD recorder (CD-R/RW drive) or
the CD-R/RW disc.
Too Many Index!
The CD already has 98 markers, the maximum number of
markers it can hold.
Drive Unformatted!
The disk drive has not yet been initialized by the VS-2400CD.
Initialize the disk drive.
If the disk drive has already been initialized by the VS-
2400CD, there is a problem with its connections. Make sure
that the disk drive is properly connected.
Operation Canceled!
You have aborted the procedure by pressing
[EXIT/NO]
.
Write Protected!
The disk drive is write-protected.
2400_app_e.book 17 ページ ２００５年４月２８日 木曜日 午後１時１４分