Filter
Top Products
67
Algorithm List
Algorithm List
Stereo Flanger
fig.08-38Parameter (full name)SettingFunction
Flg (Flanger): Adds effect similar to ascending/descending sound of a jet.
Sw (Switch) On, Off Turns the flanger on or off.
Pol (Polarity) Sync, Inv Sets the right and left phases of modulation. *3
Rate (Rate) 0.1–10.0 Hz Sets the rate at which the flanger is modulated.
Depth (Depth) 0–100 Sets the depth of modulation.
Manual (Manual) 0–100 Sets the center frequency subject to application of the
Flanger effect.
Reso (Resonance) 0–100 Enhances frequency components at around the center
frequency set with Manual. *1
CrossFBLvl (Cross-Feedback Level) 0–100 Sets the amount of the flanger sound to be returned to the
channel opposite to the one used for input. *2
FX Lvl (Effect Level). -100–100 Sets the volume of the flanger sound.
DirLvl (Direct Level) -100–100 Sets the volume of the direct sound.
EQ (Equalizer)
Sw (Switch) On, Off Turns the equalizer on or off.
Low Gain (Low Gain) -12– +12 dB Sets the boost/cut amount in the low frequency band.
Low Freq (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low Q 0.3–10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings.1 *4
Low Type Shlv, Peak Sets the type of the low frequency band equalizer
(Shlving type or peaking type).
Mid Gain (Middle Gain) -12– +12 dB Sets the boost/cut amount in the middle frequency band.
Mid Freq (Middle Frequency) 200–8000 Hz Sets the center frequency in the middle frequency band.
Mid Q (Middle Q) 0.3–10.0 Sets the width of the area around the middle frequency that
will be affected by the gain settings.
High Gain -12– +12 dB Sets the boost/cut amount in the High frequency band.
High Freq (High Frequency) 1.4–20.0 kHz Sets the center frequency in the High frequency band.
High Q 0.3–10.0 Sets the width of the area around the High frequency that
will be affected by the gain settings.1 *4
Hi Type (High Type) Shlv, Peak Sets the type of the High frequency band equalizer (Shlving
type or peaking type).
Level (Output Level) 0–100 Sets the volume after passing through the equalizer.
*1: An excessively great values for Resonance (Reso) may cause oscillation.
*2: An excessively large value for Cross-Feedback level may cause oscillation.
*3: When a mono source has been input, set “Inv” to provide spaciousness to the sound. Set “Sync” for inputting a
stereo source.
*4: If Low Type (Lo Type) or High Type (Hi Type) is set to “Shlv (Shlving Type),” the setting for Lo Q or High Q is
invalid.
Input L
Input R
Output L
Output R
Flanger L
Flanger R
3BAND EQ
3BAND EQ
2400_app_e.book 67 ページ ２００５年４月２８日 木曜日 午後１時１４分