Filter
Top Products
49
Algorithm List
Algorithm List
Parameter (full name) Setting Function
Rev (Reverb 2): Gate reverb with two modes of gate operation
Sw (Switch) On, Off Turns the reverb on or off.
Type (Reverb Type) See the column on
the previous page. Sets the reverb type.
Gate (Gate) On, Off Opens or closes the gate.
Mode (Gate Mode) Gate, Ducking Sets the gate operation type.
Time (Reverb Time) 0.1–10.0 sec. Sets the length (time) of the reverb sound.
PreDLY (Pre-Delay) 0–200 ms Sets the time until the reverb sound is output.
Densty (Density) 0–100 Sets the density of the reverb sound.
HPF (High Pass Filter) Thru, 20 - 2000 Hz Sets the frequency at which HPF starts taking effect.
Set this to “Thru” if HPF is to be disabled.
LPF (Low Pass Filter) 1.0–20.0 kHz, Thru Sets the frequency at which LPF starts taking effect.
Set this to “Thru” if LPF is to be disabled.
Thresh (Threshold) 0–100 Sets the reference volume for controlling gate operations.
Attack (Attack) 1–100 Sets the time from when the direct sound level exceeds the
threshold level until when the gate is completely open.
Releas (Release) 1–100 Sets the time from when the hold time has elapsed until the
sound is completely muted.
HoldT (Hold Time) 1–100 Sets the time from when the input falls below the threshold
level until when the release begins.
FX Lvl (Effect Level). 0–100 Sets the volume of the reverb sound.
DirLvl (Direct Level) 0–100 Sets the volume of the direct sound.
EQ (Equalizer)
Sw (Switch) On, Off Turns the equalizer on or off.
Low Gain (Low Gain) -12– +12 dB Sets the boost/cut amount in the low frequency band.
Low Freq (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low Q 0.3–10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings.1 *1
Low Type Shlv, Peak Sets the type of the low frequency band equalizer
(Shlving type or peaking type).
Mid Gain (Middle Gain) -12– +12 dB Sets the boost/cut amount in the middle frequency band.
Mid Freq (Middle Frequency) 200–8000 Hz Sets the center frequency in the middle frequency band.
Mid Q (Middle Q) 0.3–10.0 Sets the width of the area around the middle frequency that
will be affected by the gain settings.
High Gain -12– +12 dB Sets the boost/cut amount in the High frequency band.
High Freq (High Frequency) 1.4–20.0 kHz Sets the center frequency in the High frequency band.
High Q 0.3–10.0 Sets the width of the area around the High frequency that
will be affected by the gain settings.1 *1
Hi Type (High Type) Shlv, Peak Sets the type of the High frequency band equalizer (Shlving
type or peaking type).
Level (Output Level) 0–100 Sets the volume after passing through the equalizer.
*1: If Low Type (Lo Type) or High Type (Hi Type) is set to “Shlv (Shlving Type),” the setting for Lo Q or High Q is
invalid.
2400_app_e.book 49 ページ ２００５年４月２８日 木曜日 午後１時１４分