Filter
Top Products
Altivar
®
58 TRX AC Drives
Wiring Recommendations
© 2000–2003 Schneider Electric All Rights Reserved
110
09/2003
Wiring Diagram for ATV58 TRX Type E Controllers (Three Phase)
M
3φ
Brake
Resistor
(5)
PA
PB
T1
T2
T3
(2)
L1
L3
(4)
(6)
R1A
R1C
R1B
K13
K14
+10
AO1
AI1
COM
AI2
+24
LI1
LI2
LI3
LI4
(6)
0
Fw
3
3
11
Fault
Manual
Speed
Potentiometer
Drive
Run
Stop
Stop
Fw
Run
Fwd
[7]
1
3
O
(3)
L1
L3
F1
F2
(1)
Line
Reactor
L2
L2
F3
U
V
W
Notes
1. Line reactor, if required.
2. Fault relay contacts for remote signalling of the drive controller state. Contact state is shown with
the drive controller de-energized or faulted.
3. Internal +24 V. When using a +24 Vdc external supply, connect the 0 V to the COM terminal. Do
not use the +24 V terminal on the control board, but connect logic inputs to external +24 V.
4. Auxiliary on output contactor. If the controller is re-programmed, the R2 function must be
assigned to Output Contactor Command.
5. See pages 34–37 for the available braking resistor kits.
6. Manual speed potentiometer and three-position switch are factory-installed in the terminal block
cover. There is enough space in the terminal block cover to install two more 16-mm operators.
7. When user-installed wiring is added from terminals +24 to LI2 and when the drive controller
programming is at the factory settings, placing the selector switch in this position will command
the controller to run in reverse. The function of LI2 can be changed using one of the available
programming tools. See page 26 for a list of programming tools.
3 Phase Type E.eps