A SERVICE OF

logo

Open as PDF
next previous
Altivar
®
58 TRX AC Drives
Keypad Display
© 2000–2003 Schneider Electric All Rights Reserved
24
09/2003
Configuration File Storage
The keypad can store four configuration files. This is useful for configuring
multiple drives and verifying configurations.
Access Control
On the back of the keypad display is a three-position, access control switch
and a connector (see the figure to the left). Access may also be controlled by
using an access code.
The switch setting can deter unwanted tampering with adjustment and/or
configuration parameters. PROG is displayed in the upper right-hand corner
of the display when the switch is in partial lock position or total unlock
position.
The following section describes the operations allowed for the various access
control switch settings.
Accessing Menus
When a keypad display is the user interface, access is controlled by the
three-position switch on the back of the keypad.
• With the switch in the locked position, the user can:
— Select the dialog language
— Display the macro-configuration
— Identify the ATV58 TRX drive controller
— Display the state of the controller, the electrical values, and the fault
register
• With the switch in the partially locked position, the user can:
— Perform the operations possible when the switch is in locked position
— Modify settings
• With the switch in the total unlock position, the user can:
— Perform the operations possible when the switch is in locked or partial
locked positions
— Change the macro-configuration
— Modify the motor power
— Modify all configuration parameters
— Enable control via the keypad display buttons
— Store, load, or protect the parameter files
When a PC is the user interface, no access restrictions exist unless an
access code is configured (in which case, the access code must be entered
to perform any actions.)
Partial Lock Position: Adjustment parameters accessible
Locked Position: Display only; adjustment and
configuration parameters are not accessible
Total Unlock Position: Adjustment and configuration
parameters accessible
Connector:
- for direct connection to drive controller
- for remote mounting, the keypad can be
connected using a cable provided in kit
VW3A58103
Subse
q
uen
t
Power-U
ps
DIAL
OGUE
DI
S
PLAY M
O
D
E
MAIN
MEN
U
DRIVE
IDENTIFI
C
ATI
ON
Initi
al
Power-U
p
DI
S
PLAY
O
F
MA
C
R
O
-
CO
NFI
GU
RATI
ON
E
SC
Choice
o
f lan
g
ua
ge
Power, volta
ge
D
ispla
y
e
d
d
urin
g
operatio
n
The Back of the Keypad Display Showing
the Access Control Switch and Connector
KeypadRear.eps
Menu Structure
MenuFlow.eps