Filter
Top Products
PROGRAMMING Menu
SR2MAN01 11/2007 43
Method for Entering a Contact or Coil
Description
This section describes the procedures for performing the following operations:
z Entering an element,
z Modifying an element,
z Deleting an Element.
This is valid for : contact or coil elements, whether the parameters can be set or not.
Entering an
Element
When entering an element, the following rules must be observed:
z Contact: In any column except the last,
z Coil: Only in the last column.
The presence of a square, flashing cursor means an element can be inserted.
Entry procedure:
Note: Accessible only in LD mode / smart relay in STOP mode.
Step Action
1 Place the flashing cursor at the required location.
The navigation keys can be used move the cursor in the direction of the arrows on
the navigation keys .
Illustration:
2 Press the Shift key to display the contextual menu.
Illustration:
By simultaneously pressing Shift and one of the (- and +) keys, the first letter
of the element is inserted: I for a contact and Q for a coil, followed by the number 1.
3
Choose the type of element desired by pressing simultaneously on
Shift
and
+
or
-
. This
makes the different types of elements scroll down cyclically, in the following order:
z For the contacts: I, i, Z, z, M, m, Q, q, T, t, C, c, K, k, V, v, A, a, H, h, W, w, S, s.
z For the coils: M, Q, T, C, K, X, L, S.
See the chapterLD Language Elements, p. 87.
Menu / OK
ins. - + Del.