Filter
Top Products
TRANSFER Menu
SR2MAN01 11/2007 69
Backup Memory
→ Module
Transfer
Procedure for transferring the application, from the backup memory to the smart
relay, for a smart relay with LCD and keyboard:
Procedure for transferring the application, from the backup memory to the smart
relay, for a smart relay without LCD or keyboard:
Step Action
1 Insert the EEPROM cartridge (SR2 MEM02) with the program to be transferred into
the slot provided.
2
Select the transfer type: MEMORY>ZELIO using the navigation keys .
3 Confirm the transfer command with the Menu/OK key.
4 Wait for the transfer to end.
Display: > > > MODULE then TRANSFER. OK when it is complete.
5 Confirm again by pressing Menu/OK to exit the menu.
Result: the display returns to the INPUTS-OUTPUTS screen in RUN mode and to the
MAIN menu in STOP mode.
Step Action
1 Since the smart relay is not powered-on, insert the EEPROM cartridge (SR2
MEM02) into the slot provided.
2 Power up the smart relay.
During the transfer, the LED display is off.
3 Wait for the transfer to end.
During the transfer, the LED display is off, then at the end of the transfer the LED flashes.
4 z If the flashing is slow (3 Hz), the transfer has been successful, the smart relay is in
RUN, remove the EEPROM cartridge (SR2 MEM02).
z
If the flashing is rapid (5Hz), the transfer has failed due to incompatibility between the
configuration necessary for the program to be transferred and that of the smart relay.
Note: When the smart relay is in STOP mode, the LED display is lit and does not
flash.