Filter
Top Products
TRANSFER Menu
68
SR2MAN01 11/2007
Module →
Backup Memory
Transfer
Procedure for transferring the application, from the smart relay to the backup
memory:
Note: if an application is already present in the backup memory, it will be
overwritten by the new transfer (no test is performed to check the memory is free).
Note: It is not possible to directly transfer an application created with version V2 of
the programming software from the SR2 MEM01 memory to the smart relay if this
latter contains version V3 firmware.
In this case, see what action you should take in the section Program incompatible
with firmware of the module (see Application incompatible with firmware on the
smart relay, p. 70).
For more information about the compatibility of the memory cartridges, see
Compatibility between the memory cartridges and the version of the firmware on
the smart relay, p. 195.
Step Action
1 Insert the EEPROM cartridge (SR2 MEM02) into the slot provided.
2
Select the transfer type: MEMORY>ZELIO using the navigation keys .
3 Confirm the transfer command with the Menu/OK key.
(Enter the password if the program is password-protected).
4 Wait for the transfer to end.
Display: > > > MEMORY then TRANSFER. OK when it is complete.
5 Confirm again by pressing Menu/OK key to exit the menu.
Result: The display returns to the INPUTS-OUTPUTS screen in RUN mode and to
the MAIN menu in STOP mode.