Filter
Top Products
TRANSFER Menu
70
SR2MAN01 11/2007
Possible Errors Below are the possible errors and, for each case, the messages that are displayed:
z Absence of backup memory
Error message:
TRANSFER ERROR: NO MEMORY
z Configurations of the hardware and program to transfer incompatible
Error message:
TRANSFER ERROR: CONFIG INCOMPAT (hardware or software reference
numbers).
Refer to the DEFAULT Menu, p. 77 chapter to consult the error number and clear it.
Application
incompatible
with firmware on
the smart relay
If the application stored in backup memory SR2 MEM01 was created with a version
of the programming software that is incompatible (see Compatibility between the
memory cartridges and the version of the firmware on the smart relay, p. 195) with
the firmware of the target smart relay, proceed as follows:
Note: The transfer of one module program to another via a memory card is only
possible between smart relays with the same reference. For example, it is
impossible to transfer a program from a module with a clock to a module that does
not have one.
Step Action
1
Load the application from the backup memory to a smart relay with compatible firmware.
Note: If no smart relay has firmware that is compatible with the application, use the
programming software version that was used to create the application to load
compatible firmware into the target smart relay:
2 Use the version of the programming software that was used to create the application
to load it from the smart relay toward the PC.
3 Save the application uploaded in step 2.
4 Launch the latest version of the programming software.
5 Open the application saved in step 3.
Result: The programming software converts the application.
6
Load the converted application and the associated firmware to the target smart relay.