Filter
Top Products
122
CAUTION:
Never change the setting of any of the DIP switches when the
power is on. The printer only reads the DIP switch settings at
the moment the power is turned on. Turn off power to both the
computer and the printer when changing settings, and turn on
again to use the new settings.
Table A-1 shows a summary of DIP switch functions.
Table A-1
DIP switch settings
I Switch I ON 10FF I
I Switch 1 I
1-1 ] n-inch page length I12-inchpage length
I
I 1-2
IDraft characters I
NLQcharacters I
I 1-3 IPrint “normal zero” IPrint “slash zero” I
1-4
No bottom margin Setbottommarginto 1 inch
1-5 Paper-outdetected Paper-outnot detected
1-6
Set SELECT IN signal to Not fixed
LOW
1-7
Characterset #l
Characterset #2
1-8 LF from host
Auto LF with CR
I 1-9 I(Not used) I
1-1o I(Not
used)
Switch 2
2-1
/ lznoredownloadcharacters IEnabledownloadcharacters
I 2-2 I I
tza
Internationalcharacter set selection– see Table A-2.
I
I
I 2-5 ISet standard mode ISet IBM mode I
I 2-6 I(Not used) I
SWITCH FUNCTIONS
Switch Function
1-1 This switch sets the default page length. If this
switch is on the default page length is 11 inches.
If this switch is off the default page length is 12
inches. This switch is set on at the factory.