Star Micronics NX-2415II Printer User Manual


 
I
DOWNLOAD CHARACTER
Define download characters
Mode
ASCII
Decimal Hexadecimal
<ESC>. “’&”<0> nf 27 38 0 nl
IB 26 00 n/
Std.
,t~
mO ml
m2
n2 mo ml m2 n2 mo m/ m2
d[ (u d.! dl w ([.1
dl d2 d.1
Defines one or more new characters and stores them in RAM for
later use. EDS switch A-3 must be set OFF; otherwise RAM is
used
as an inputbuffer, not downloading characters, and this command is
ignored.
nl is the character code of the first character defined and /12is the
character code of the last character defined. nl must be equal to or
less than n2.
The data for each character startwith three bytes specifyingpropor-
tional spacing attributes: the first byte, mo, specifies the left of the
character; the second byte, ml, specifies the character width; the
third byte, m2, specifies the right of the character.
These values must not exceed the following maximum limits:
Character mode
ml mO+ ml + n/2
Draft
LQ pica
LQ elite
LQ semi-condensed
LQ proportional
Draft super/subscript
LQ super/subscript
LQ prop. super/subscript
9
31
27
19
38
7
19
38
12
36
30
24
42
12
36
42
Next comes the dot data. Normal character height is 24 dots, sothere
must be 3 x m/ bytes of dot data. If the printer is in super/subscript
mode, however, the character height is 16dots, so there must be 2 x
ml bytes of dot data.
Each data byte indicateseightverticaldots,withthemostsignificant
bit being the top dot, and the least significant bit being the bottom
dot.
94