Star Micronics NX-2415II Printer User Manual


 
Printer test works, but printer does not print when attached to computer
IProbable Cause
IAction
I
Printer cable has a problem.
Make sure that the printer cable iscorrectly
connected at both ends, printer and com-
puter.
Problem with the application
Refer to your application program manual.
program.
Printer sounds the audible alarm
\Probable Cause
IAction
This might indicate an error
or normal operation.
Check the statusofthecontrolpanel indica-
tors and see “Conditions indicated by beep
tones” in Chapter 4.
Selected pitch or font is being changed
]Probable Cause
IAction
Set your printer in Font/Pitch lock. See
“Pitch lock mode” and “Font lock mode” in
Chapter 4.
Printer does not feed paper
Probable Cause
Paper isjamming.
Adjustment lever is set in-
correctly.
Releaseleverissetincorrectly.
\Fanfold form isparked.
Action
Remove all forms and pieces of paper.
Check the setting of the adjustment lever.
See “Adjusting theprintinggap” in Chapter
3.
Check the setting of the release lever. This
lever must be set to the back for cut-sheet
forms (.~ ), and forward for fanfold forms
( ~).
Unpack the fanfold paper.
48