Filter
Top Products
Loading the paper
If you are going to load the paper with the optional Pull tractor unit, refer to
Chapter 7.
1.
2.
3.
4.
Place a stack of fanfold paper behind and at least one page-length below
the printer.
Turn the printer’s power OFF.
Push the release lever forward. This has the effect of releasing the paper
from the platen roller, and engaging the tractor feed.
Remove the rear cover. Grip it by its rear edge and lift upwards and
backwards as in Figure 3-7.
I
Figure 3-7. Remove the rear cover.
5. With the tractor covers open, mount the paperby aligning holes with the
pins on the tractor unit.
6. Adjustthespacingofthetractorunitsby slidingthemalongthebar, using
the clamp lever at the back of each unit to release them and lock them in
position. The unit is released when the clamp lever is down and locked
when the clamp lever is up.
23