Star Micronics NX-2415II Printer User Manual


 
Tractor cober
CIamp lever
Figure 3-8. Mount the fanfold paper over the tractor units.
7. Now close the tractor covers, again making sure that the paper holes are
aligned with the pinson the tractor units. If they are notaligned properly,
you will have problems with paper feeding, possibly resulting in tearing
and jamming of the paper.
8. Remount the rear cover. Hold it tilted upward and insert the four tabs at
the front into their slots. Then rotate the cover downwards, pressing
down on the thumb pads on the left and right to snap it into place.
9. Mount the paper guide in the horizontal position, as shown in Figure 3-
9. This will separate the printed from the unprinted paper.
10.Turn ON the power at the switch located at the front of the printer. The
printer will beep, indicating that the paper is not yet fully loaded. The
POWER indicator will also flash to confirm this.
11.Now press the (SET/EJECO button. The paper will be fed and adjusted
past the print head to a position ready for printing.
12.If you want to set the paper to a different position, set the printer off-line
by pressing the (ONLINE) button,then setthepaperby using the micro-
feed function. (For details, refer to Chapter 4.)
24