Star Micronics NX-2415II Printer User Manual


 
The parallelcablewhich youcan usehasa25-pinD-typeplugatoneend, and
a 36-pin Centronics connector at the other.
Follow the procedure below to connect the interface cable:
1. Turn off the power switch on both the printer and the computer.
2. Plug the cable’s Centronics connector into the socket on the side of the
printer as shown in Figure 2-9.
Make sure that you press the plug into the interface connector.
I +“ //” \EsY Ll
Figure 2-9. Connect the interface cable.
3. Move both clips inside the extended prongs on the sides of the plug until
you hear a click.
Figure 2-70. Move the clips until you hear a click.
4. Plug the 25-way plug into the parallel socketonyourcomputer. This will
probably be Iabelled“Printer”, “Paral]el”, “PRN”, “LpTl” or
something
similar.
14