Star Micronics NX-2415II Printer User Manual


 
This position remains valid until you power off the printer. If you want to
retain this position even after you turn off the power, store it using the Macro
Definition function, which is described later.
Note that you can only change this value immediately after loadingpaper. If
you feed paper, you cannot change the auto loading value.
Clearing the buffer/All reset
The printer stores received data in a large memory buffer. This creates a
problem when youwanttoabandon a printingjob and restart: the printermay
be holding more data in its buffer than it has actually printed, and this
unprinteddatamustbecleared outbeforerestarting.Turning power off isone
way to clear the buffer, but there is another way:
1. Haltthe printingprogram onthe computer.Ifprintingstopsimmediately,
the buffer isclear and the rest of thisprocedure isunnecessary.Ifprinting
does not stop, continue as follows:
2. Press the (ON LINIij)button to set the printer off-line. Printing will now
stop, but there may be data remaining in the buffer.
3. Press and hold down the(m) button.
4. While pressing the(-T) button down, press and hold down the
(ONLINE)button.Continueholding these two buttonsdown and you will
hear a beep tone signaling that the buffer has been cleared. If you hold
these buttons down longer, you will hear three beep tones and theprinter
has been initialized to the power-on default settings.
5. Release these buttons, make any necessary control panel settings, then
set the printer back on-line.
It isessential to stop the printing program on the computer before you go off-
line. Otherwise, when you go back on-line the computer will start sending
data again and the printer will continue printing, with data missing from
when the buffer was cleared.
33