Star Micronics NX-2415II Printer User Manual


 
It isa good idea to try out different settings in order to ascertain which setting
gives the best results in terms of print quality.
NOTE: Printing with an inappropriate gap may drastically shorten the life
of the print head.
The table below gives recommended settings:
Weight(g/mz) Thickness(mm)
Recommended
‘aPer ‘J’pe
(Each sheet)
(Total) Lever position
Single
52 to 90
0.07too. 12
2 or 3
2-ply
40 to 52 0.12 to 0.14
2 or 3
3-ply
40 to 52
O.18to0.21
3 or 4
LOADING SINGLE SHEETS
This section will take you through the procedure for loading single sheets of
paper. IfyouareusingtheoptionalAutomaticSheetFeeder(SF-15DJ),refer
to Chapter 7.
The paper path for cut forms is shown in Figure 3-3.
I
Figure 3-3. Paper path for cut forms
19