Star Micronics NX-2415II Printer User Manual


 
Assigning a value of character space
Besides being able to specify the actual width of the character, this printer
allows you to specify the position in the standard grid where the character
will print. You must specify the dot column in which the printed character
starts and the dot column in which the character ends. Why, you may ask,
would you want to define a character this way instead of merely defining the
overall width of the character’?Because this printer’s proportional character
definitions can also be used to print normal width characters, and by
centering even the narrow characters inthe complete grid they willlookgood
even if you are not printing them proportionally.
The three bytes are used to specify the width of the character and the space
to be allowed on either side of it. The left space (in dot columns) is specified
by and the right space isspecified by byte specifies
the width of the character indots. By varying thewidth of the character itself
and the spaces around it, you can actually create proportional width charac-
ters.
When defining characters, thenumber of printed columns and the sum
of side spaces and the character width (mO+
+ cannot exceed the
value shown below.
Character mode
+ +
Draft characters
9
12
LQ pica characters
31
36
LQ elite characters
27
30
LQ semi-condensed
19 24
LQ proportional
37
42
Draft super/subscript
7
12
LQ super/subscript
19 36
LQ prop. super/subscript
37
42