Star Micronics NX-2415II Printer User Manual


 
chapter2
SETTING UP THE PRINTER
This chapter describes the following procedures for setting up your new
printer. If you have optional accessories. refer to Chapter 7 after setting up
the printer.
.
.
.
.
.
.
Printer placement
Unpacking the printer
Installing the platen knob
Installing the ribbon cartridge
Connecting the printer to your computer
Configuring your software for the printer
PRtNTER PLACEMENT
Before you start setting up your printer, make sure that you have a suitable
place on which to locate it. By “a suitable place”, we mean:
.
.
.
.
.
A firm, level surface which is fairly vibration-free
Away from excessive heat (such as direct sunlight, heaters, etc)
Away from excessive humidity
Away’from excessive dust
A“steady power supply that is not subject to power surges should be
connected to the printer.
Forexample. donotconnect the printer tothe samecircuitasa large,noise-
producing appliance such as a refrigerator or an air conditioner.
Make sure the line voltage is the voltage specified on the printer’s
identification plate.
If you are connecting your printer with a parallel interface, make sure that
the cable iswithin 2m (6ft) of the printer. An RS-232 connection usingthe
optional IS-8XL interface cartridge can be made over longer distances.
7