Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
8
PRECAUTIONS
1. Installation
1
The e-STUDIO45/35 should be installed by a qualified service technician.
Note: The packing material should be disposed of properly.
2
To obtain the best possible results, this copier should be used in conjunction with a
dedicated AC power line at the following ratings.
220–240V, 50/60Hz, 8A
Notes:
1. The use of other appliances or other equipment on the same line as this copier may adversely
affect performance and copy quality.
2. Be sure to use a 3-conductor, grounded wall outlet.
3. In areas where a 2-pin plug is used, the copier must be grounded for safety.
Never ground it to a gas pipe, a water pipe, or any other object not suitable for grounding.
3
After a suitable place has been selected for the installation of the e-STUDIO45/35,
please do not change it. Avoid excessive heat, dust, vibration and direct sunlight.
Also, provide proper ventilation as the copier emits a small amount of ozone.
Notes:
1. The recommended environmental range for use is as follows:
• Temperature: 10~30°C/50~86°F
• Humidity: 20~85% RH
2. To insure optimal operation, allow clearances of at least 80cm on the left, 80cm on the right and
10 cm in the rear (refer to the illustration below).
The socket-outlet shall be installed near the equipment and shall be easily accessible.
80cm
80cm