Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
7-24
WHEN GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
Note
If test stapling fails to be performed and the following mes-
sage remains displayed, repeat the above procedure from
steps 1 to 7.
Set staple cartridge
Hanging-Type Finisher
1
By pulling the lever, move the finisher away care-
fully from the copier.
2
Holding the sides of the staple cartridge, slide it out.
3
Turn the staple cartridge upside down, and perform
steps 3 to 5 of the procedure for adding staples to
the Console-Type Finisher ( Page 7-21) .
4
Turn the staple cartridge to its normal position and
push it back into the stapler.
• Insert the cartridge until it is caught by the claw and fixed
with a click sound.
Note
If the following message remains displayed, repeat the above
procedure from steps 1 to 4.
Set staple cartridge
5. ADDING STAPLES (Cont.)