Filter
Top Products
Operating Basics
Portégé M200 415
Portégé M200 Version
1
Last Saved on 03/11/2003 12:04
ENGLISH using Euro_M.dot –– Printed on 03/11/2003 as IM_M20EN
The external diskette drive should be placed on a flat, horizontal surface
when in use. Do not set the drive on an incline greater than 20° while it is
operating.
Do not set anything on top of the diskette drive.
If you need to boot the computer from the diskette drive or if you use an
OS that does not support USB, you must set the USBFDD Legacy
Emulation feature in HW Setup to Enabled. Refer to the USB section in
Chapter 7, HW Setup.
Connecting the USB diskette drive
To connect the drive, plug the diskette drive connector into a USB port.
Refer to the figure below.
Make sure the connector is right side up and properly aligned with the
socket. Do not try to force the connection, doing so can damage the
connecting pins.
USB CONNECTOR
DISKINUSE
INDICATOR
DISKETTE SLOT EJECT BUTTON
Connecting the diskette drive to the computer
If you connect the diskette drive after turning on the computer, it will take
about 10 seconds for the computer to recognize the drive. Do not
disconnect and reconnect before 10 seconds has elapsed.