Filter
Top Products
2 Troubleshooting Procedures 2.14 Sound Troubleshooting
Procedure 2 Connector Check
The sound function-wiring diagram is shown below:
Any of the connections may be disconnected. Disassemble the computer following the steps
described in Chapter 4, Replacement Procedures and perform the following checks:
1. If the stereo speakers do not work correctly, perform Check 1.
2. If the headphone does not work correctly, perform Check 2.
3. If the microphones do not work correctly, perform Check 3.
Check 1 If the stereo speakers do not work properly, the speaker cable may be
disconnected. Make sure the speaker cable is firmly connected to PJ3202 on the
sound board. If the stereo speakers are still not functioning properly, go to Check
4.
Check 2 If the headphone does not work properly, the headphone cable may be
disconnected. Make sure the headphone cable is firmly connected to PJ6000 on
the sound board. If the sound function still does not work properly, go to Check 4.
Check 3 If the microphones do not work properly, the internal microphone cable or
external microphone cable may be disconnected. When the internal microphone
malfunctions, make sure the internal microphone cable is firmly connected to
PJ6001 on the sound board. When using the external microphone, make sure the
external microphone cable is firmly connected to PJ6002 on the system board. If
the microphones are still not functioning properly, go to Check 4.
Check 4 Make sure the sound board flexible cable is firmly connected to PJ9510 on the
sound board and to PJ9500 on the system board.
If the sound board flexible cable is disconnected, connect it firmly and perform
Procedure 1. If the sound function is still not functioning properly, go to
procedure 3.
2-54 TECRA M2 Maintenance Manual (960-468)