Filter
Top Products
4 Replacement Procedure 4.27 Fluorescent Lamp
9. Install the protection cover S (A), protection cover G (B), aluminum tape (C) and
fixing tape for lead wire (D). Use new parts.
• Stick the protection covers in the order of (B), (A) to the standard line for
fitting pin.
• Stick the aluminum tape (C) following the sticking standards.
Long sides: Stick to the mark-off line of the lamp cover on the back of bezel.
Short sides: Stick to the edge of lamp cover.
• Stick the fixing tape for lead wire (D) following the sticking standards.
Long sides: Stick to the outline of the LCD module.
Short sides: Stick so that the wire covers the screws.
(B) Protection cover G
(C) Aluminum tape
Latch
(D) Fixing tape
for lead wire
(A) Protection cover S
Figure 4-79 Replacing Sharp fluorescent lamp (SXGA+) (9)
4-106 TECRA M2 Maintenance Manual (960-468)