Filter
Top Products
4.22 Speaker 4 Replacement Procedures
Installing the Speaker
To install the speaker, follow the steps below and refer to figures 4-44 and 4-45.
1. Install the speaker (left) to the slot.
2. Install the speaker holder (left) while inserting its tip to the slot and secure it with
the following screw.
• M2.5×6B FLAT HEAD screw ×1
3. Install the speaker (right) to the slot.
4. Install the speaker holder (right) while inserting its tip to the slot and secure it with
the following screw.
• M2.5×6B FLAT HEAD screw ×1
5. Install the speaker cable to the slot while passing through the guide.
S
p
eaker cable
Acetate tape
Figure 4-45 Installing the speaker cable
6. Stick two acetate tapes to secure the speaker cable.
TECRA M2 Maintenance Manual (960-468) 4-65