Filter
Top Products
4.7 Slim select bay module 4 Replacement Procedures
4.7 Slim select bay module
Removing the Slim select bay module
To remove the slim select bay module, follow the steps below and refer to figures 4-9 and 4-
10.
CAUTION: The slim select bay module can become hot with use. Be careful when
removing the module.
1. Remove the following screw securing the latch and drive the removed screw into the
screw hole. (The slim select bay is unlocked.)
• M2.5×4B FLAT HEAD screw ×1
2. While sliding the latch toward the arrow direction in the figure, slide the slim select
bay module outward to disconnect it from the system board.
M2.5×4B FLAT HEAD
Screw hole
Latch
DVD-ROM drive
Figure 4-9 Removing the slim select bay module (for example DVD-ROM drive)
TECRA M2 Maintenance Manual (960-468) 4-19