Filter
Top Products
3 Tests and Diagnostics 3.20 IEEE1394 Test
3.20 IEEE1394 Test
This section describes how to perform the IEEE1394 test with the test program.
Toshiba MS-DOS is required to run the DIAGNOSTICS TEST PROGRAM. To start the
DIAGNOSTIC TEST PROGRAM, follow these steps:
(a) Insert the Diagnostics disk in the floppy disk drive and turn on the computer.
(The Diagnostics Disk contains the MS-DOS boot files.)
The following menu will appear:
***********************************************************************
* ------------------------------------------------------------ *
* IEEE1394 [TSB!”LV28] test menu ( For Repair ) VX.XX *
* ------------------------------------------------------------ *
* *
* ============ Select test No. and [Enter] ============ *
* *
* 1 : ... Ieee1394 test *
* 2 : ... Responder tool *
* 3 : ... ID Check *
* *
***********************************************************************
Select [1-3]?
(b) To execute the TEST, select the test number you want to execute and press Enter.
Subtest 01 IEEE1394 test
This program checks the data transporting between responder machine and
target machine.
NOTE: Use another computer that can communicate by IEEE1394 (i. Link) cable as a
reference machine to perform this test.
Subtest 02 Responder tool
This program initializes the machine responder.
Subtest 03 ID Check
This program checks the GUID.
3-50 TECRA M2 Maintenance Manual (960-468)