Filter
Top Products
4.8 Keyboard 4 Replacement Procedures
Installing the Keyboard
To install the keyboard, follow the steps below and refer to figures 4-11 to 4-15.
1. Place the keyboard face down on the cover.
2. Connect the keyboard cable to the connector PJ3200 on the system board.
3. Insert the guides of the keyboard support plate first, then place the keyboard support
plate on the keyboard cable. Secure the keyboard support plate with the screw (with
e-ring).
4. Turn the keyboard face up and set it. Make sure that there is no gap between the
keyboard and the edge of the cover.
5. Secure the keyboard with the following screws.
• M2.5×2.8B FLAT HEAD screw ×2
6. Install the keyboard holder and press to secure the latches.
7. Close the display and turn the computer face down.
8. Secure the keyboard with the following screws.
• M2.5×3S S-FLAT HEAD screw ×1
TECRA M2 Maintenance Manual (960-468) 4-27