Filter
Top Products
4 Replacement Procedures 4.14 Bluetooth module
4.14 Bluetooth module
Removing the Bluetooth module
To remove the Bluetooth module, follow the steps below and refer to figure 4-26.
CAUTION: Do not try to remove the Bluetooth module with the computer turned on.
You can damage the computer or Bluetooth module. Do not touch the
connectors on the Bluetooth module on the computer. Debris on the
connectors may cause Bluetooth access problems.
1. Remove the Bluetooth cable (brown) from the Bluetooth module using an antenna
coaxial cable disconnector.
2. Remove the following screw securing the Bluetooth module.
• M2×3S S-FLAT HEAD screw ×1
3. Lift up the Bluetooth module carefully from the connector PJ4400 on the sound
board.
M2
×
3S S-FLAT HEAD
Bluetooth module
Bluetooth cable
Figure4-26 Removing the Bluetooth module
4-42 TECRA M2 Maintenance Manual (960-468)