Filter
Top Products
4 Replacement Procedures 4.26 Hinge
4-86 TECRA M2 Maintenance Manual (960-468)
Installing the Hinge
To install the hinge, follow the steps below and refer to figures 4-56 to 4-59.
1. Pass the LCD cable through the hole.
2. Set the both sides hinges and secure them with the following screws (on the back).
• M2.5×6 Tapping screw ×2
3. Secure the both sides hinges with the following screws.
• M2.5×5B FLAT HEAD screw ×2
4. Secure the following screws and stick the mask seals.
• M2.5×2.8B FLAT HEAD screw ×2
5. Install the hinge cap.
6. Set the LCD cable holder and secure it with the following screw.
• M2.5×4B FLAT HEAD screw ×1