Filter
Top Products
4 Replacement Procedure 4.27 Fluorescent Lamp
4.27.2 Replacing the 14.1-inch SXGA+ Sharp Fluorescent Lamp
CAUTION: When replacing the fluorescent lamp, wear finger covers or gloves to avoid
contaminating or damaging the LCD panel. Be careful not to let dust or
other foreign substance into the module.
To replace the 14.1-inch SXGA+ Sharp fluorescent lamp, follow the steps below and refer to
figures4-71 to 4-80.
1. Turn the LCD module face down, and remove the protection cover S (A), protection
cover G (B), aluminum tape (C) and fixing tape for lead wire (D).
NOTE: 1) Be careful not to damage the TCP or chips.
2) Discard the tapes removed.
(B) Protection cover G
(C) Aluminum tape
Latch
(D) Fixing tape for
lead wire
(A) Protection cover S
Figure 4-71 Replacing Sharp fluorescent lamp (SXGA+) (1)
4-98 TECRA M2 Maintenance Manual (960-468)