Filter
Top Products
4 Replacement Procedures 4.24 LCD unit/FL inverter
4. Connect the LCD cable to the connector on the back of the LCD unit. Stick the
copper tape on the LCD cable.
CAUTION:
5. Seat the LCD unit and secure it with the following screws.
• M2×4Z S-FLAT HEAD screw ×4
6. Stick the four mask seals on the sides of the LCD unit.
7. Connect the FL cable and the HV cable to the FL inverter.
8. Seat the FL inverter and stick the insulator on the FL inverter of the FL cable side.
9. Secure the FL inverter with the following screw.
• M2×4Z S-FLAT HEAD screw ×1
10. Install the LCD mask while hooking the latches.
11. Secure the LCD mask with the following screws.
• M2.5×6B FLAT HEAD screw ×2
12. Stick the two mask seals.
4-78 TECRA M2 Maintenance Manual (960-468)