Western Telematic AFS-16-1 Switch User Manual


 
13-1
13. Operation via SNMP
If SNMP Access Parameters have been defined as described in Section 5.9.6, then you
will be able to manage user accounts, control power and reboot switching and display
unit status via SNMP. This section describes SNMP communication with the
AFS-16 unit, and lists some common commands that can be employed to manage
users, control switching and reboot actions and display unit status.
13.1. AFS-16 SNMP Agent
The AFS-16’s SNMP Agent supports various configuration, control, status and event
notification capabilities. Managed objects are described in the WTI-AFS-MIB.txt
document, which can be found on the CDROM included with the AFS-16 unit, or on the
WTI web site (http://www.wti.com). The WTI-AFS-MIB.txt document can be compiled for
use with your SNMP client.
13.2. SNMPv3 Authentication and Encryption
For SNMPv3, the AFS-16 supports two forms of Authentication/Privacy: Auth/noPriv
which requires a username/password, but does not encrypt data going over the internet
and Auth/Priv which requires a username/password AND encrypts the data going over
the internet using DES (AES is not supported at this time). For the Password protocol,
the AFS-16 supports either MD5 or SHA1.
13.3. Configuration via SNMP
AFS-16 User accounts can be viewed, created, modified, and deleted via SNMP. User
accounts are arranged in a table of 128 rows, and indexed 1-128. User account
parameters, as seen through the SNMP, are summarized below.
• userTable::userName – 32 character username
• userTable::userPasswd – 16 character password
• userTable::userAccessLevel – Account access level.
0 ViewOnly Access
1 User Access
2 Superuser Access
3 Administrator Access