Western Telematic AFS-16-1 Switch User Manual


 
7-8
Alarm Configuration
• EmailMessage: Enables/Disables email notification for this alarm. (Default = On.)
Note:Ifeitherofthe"CopytoAllTriggers"optionsisselected,thenemail
notificationforotheralarmswillbeswitchedOnorOffasindicatedbythis
parameter.
Address1,2,and3: These parameters are used to determine which of
the three email addresses defined via the "Email Messages" menu (see
Section 5.9.11) will receive the email alarm notification messages generated
by this alarm. The Address parameters can be used to select one, or any
combination of the addresses defined via the Email Messages menu.
(Default = All On.)
Note:IfEmailaddresseshavebeenpreviouslyspecified,thenthetextunder
theparameterswilllistthecurrent,userdefinedemailaddresses.
• Subject: This parameter is used to define the text that will appear in the "Subject"
field for all email notification messages generated by this alarm. (Default = "Alarm:
Invalid Access Lockout.")
• ContactOutputEnable: Activates/deactivates the output contacts on the Control
Module AUX Connector. When the Contact Output Enable parameter is set to "On",
the Common line will be switched from the Normally Closed contact to the Normally
Open contact when an Invalid Access Lockout Alarm is generated. For more
information on the Output Contacts, please refer to Section 7.1. (Default = On.)
Note:Ifeitherofthe"CopytoAllTriggers"optionsisselected,thentheContact
OutputEnableparameterforotheralarmswillalsobeenabledordisabledas
specifiedbythisparameter.