Western Telematic AFS-16-1 Switch User Manual


 
5-27
Basic Configuration
5.9.2. Network Parameters
In the Text Interface, these parameters are accessed via the Network Configuration
menu (Figure 5.9.) In the Web Browser Interface, these parameters can be found by
clicking the "Network Parameters" link on the left hand side of the screen to display the
Network Parameters menu.
Note:TheIPAddress,SubnetMask,GatewayAddressandDHCPstatus
cannotbechangedviatheWebBrowserInterface.Inordertochangethese
parameters,youmustaccesstheAFS-16viatheTextInterface.
• IPAddress: (Default = 192.168.168.168.)
• SubnetMask: (Default = 255.255.255.0.)
• GatewayAddress: (Default = undefined.)
• DHCP: Enables/Disables Dynamic Host Configuration Protocol. When this option
is "On", the AFS-16 will perform a DHCP request. Note that in the Text Interface, the
MAC address for the AFS-16 is listed on the Network Status Screen.
(Default = Off.)
Note:Beforeconfiguringthisfeature,makecertainyourDHCPserverissetup
toassignaknown,fixedIPaddress.YouwillneedthisnewIPaddressinorder
toreestablishanetworkconnectionwiththeAFS-16unit.
• TelnetAccess: Enables/disables Telnet access. When Telnet Access is "Off," users
will not be allowed to establish a Telnet connection to the unit. (Default = Off.)
• TelnetPort: Selects the TCP/IP port number that will be used for Telnet
connections. In the Text Interface, this item is defined via a submenu, displayed
when the Telnet Access parameter is selected. (Default = 23.)
• SSHAccess: Enables/disables SSH communication. (Default = On.)
• SSHPort: Selects the TCP/IP port number that will be used for SSH connections.
Note that in the Text Interface, this item is defined via a submenu, which is
displayed when the SSH Access parameter is selected (item number 22.)
(Default = 22.)
• HTTPAccess(WebAccess): Enables/disables the Web Browser Interface.
When disabled, users will not be allowed to contact the unit via the Web Browser
Interface. (Default = Off.)
• HTTPPort: Selects the TCP/IP port number that will be used for HTTP
connections. (Default = 80.)
• HTTPSAccess: Enables/disables HTTPS communication. For instructions on
setting up SSL encryption, please refer to Section 14. (Default = Off.)