Western Telematic AFS-16-1 Switch User Manual


 
15-2
Saving and Restoring Configuration Parameters
15.2. Restoring Saved Parameters
This section describes the procedure for using your terminal emulation program to send
saved parameters to the AFS-16.
1. Start your terminal emulation program and access the AFS-16’s Text Interface
command mode using an account that permits Administrator level commands.
2. Configure your terminal emulation program to upload an ASCII text file.
3. Upload the ASCII text file with the saved AFS-16 parameters. If necessary, key in
the file name and directory path.
4. Your terminal emulation program will send the ASCII text file to the AFS-16. When
the terminal program is finished with the upload, make certain to terminate the
Upload mode.
Note:IftheAFS-16detectsanerrorinthefile,itwillrespondwiththe"Invalid
Parameter"message.Ifanerrormessageisreceived,carefullycheckthe
contentsoftheparametersfile,correcttheproblem,andthenrepeattheUpload
procedure.
5. If the parameter upload is successful, the AFS-16 will send a confirmation message,
and then return to the command prompt. Type /S and press [Enter], the Status
Screen will be displayed. Check the Status Screen to make certain the unit has
been configured with the saved parameters.