Western Telematic AFS-16-1 Switch User Manual


 
16-1
16. Upgrading AFS-16 Firmware
When new, improved versions of the AFS-16 firmware become available, the "Upgrade
Firmware" function can be used to update the unit. Updates can be uploaded via FTP
or SFTP protocols.
Notes:
• TheFTP/SFTPserverscanonlybestartedviatheTextInterface.
• Allotherportswillremainactiveduringthefirmwareupgradeprocedure.
• Iftheupgradeincludesnewparametersorfeaturesnotincludedinthe
previousfirmwareversion,thesenewparameterswillbesettotheirdefault
values.
• Theupgradeprocedurewillrequireapproximately15minutes.
1. Obtain the update file. Firmware modifications can either be mailed to the
customer, or downloaded from WTI. Place the upgrade CDR in your disk drive or
copy the file to your hard drive.
2. Access Text Interface command mode via Serial Port, Telnet or SSH client session,
using a username/password and port that permit Administrator level commands.
3. When the command prompt appears, type /UF and then press [Enter]. The
AFS-16 will display a screen which offers the following options:
a) StartFTP/SFTPServersOnly(DoNOTdefaultparameters): To proceed
with the upgrade, while retaining user-defined parameters, type 1 and press
[Enter]. All existing parameter settings will be restored when the upgrade is
complete.
b) StartFTP/SFTPServers&Default(KeepIPparameters&SSHKeys): To
proceed with the upgrade and default al user-defined parameters except for the
IP Parameters and SSH Keys, type 2 and press [Enter]. When the upgrade is
complete, all parameter settings except the IP Parameters and SSH Keys, will
be reset to factory default values.
c) StartFTP/SFTPServers&Default(DefaultALLparameters): To proceed
with the upgrade, and reset parameters to default settings, type 3 and press
[Enter]. When the upgrade is complete, all parameters will be set to default
values.
d) StartFTP/SFTPServersforSlipStreamUpgrade: This option will upgrade
only the WTI Management Utility, without updating the AFS-16's operating
firmware. To update the WTI Management Utility only, type 4 and
press [Enter].
Note that after any of the above options is selected, the AFS-16 will start the
receiving servers and wait for an FTP/SFTP client to make a connection and upload
a valid firmware binary image.