Filter
Top Products
Configuration
Control Panel Parameters
98
11342L-001 Rev. A 105SL User Guide 6/30/06
Print Server LCD Displays
The menu options shown in Table 10 display only if you have a print server installed.
Table 10 • Print Server Parameters (Page 1 of 4)
Parameter Action/Explanation
Load LAN Source
1
This parameter, which serves the same function as the ^NP ZPL command,
specifies whether to use the printer’s or the print server’s IP settings at
bootup.
Default: PRINTER
Selections: PRINTER, PRINTSERVER
To change the value shown:
1. Press PLUS () or MINUS (–) to toggle between the options.
Check for Wired PrintServer
1
This parameter, which serves the same function as the ^NB ZPL command,
tells the printer whether to search for a wired print server at bootup.
Default: NO
Selections: YES, NO
To change the value shown:
1. Press PLUS () or MINUS (–) to toggle between the options.
Specify IP Protocol
2
Allows either the user (permanent) or the server (dynamic) to select the
IP address. If a dynamic option is chosen, this selection determines the
method(s) by which the print server (wired or wireless) receives the IP
address from the server.
Default: ALL
Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP,
DHCP AND BOOTP, PERMANENT
Note • Use of GLEANING ONLY is not recommended when the
Wireless Print Server is installed.
To change the value shown:
1. Press PLUS () or MINUS (–) to scroll through the options.
1 Appears only when the ZebraNet Wireless Print Server is installed.
2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
LOAD LAN FROM?
PRINTER
WIRED PS CHECK?
NO
IP PROTOCOL
ALL